Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261 262 263 264 265 266 267 268 | // SPDX-License-Identifier: GPL-2.0+ // Copyright 2018 IBM Corporation #include <linux/clk.h> #include <linux/dma-mapping.h> #include <linux/irq.h> #include <linux/mfd/syscon.h> #include <linux/module.h> #include <linux/of.h> #include <linux/of_reserved_mem.h> #include <linux/platform_device.h> #include <linux/regmap.h> #include <linux/reset.h> #include <drm/drm_atomic_helper.h> #include <drm/drm_crtc_helper.h> #include <drm/drm_device.h> #include <drm/drm_fb_cma_helper.h> #include <drm/drm_fb_helper.h> #include <drm/drm_gem_cma_helper.h> #include <drm/drm_gem_framebuffer_helper.h> #include <drm/drm_probe_helper.h> #include <drm/drm_simple_kms_helper.h> #include <drm/drm_vblank.h> #include <drm/drm_drv.h> #include "aspeed_gfx.h" /** * DOC: ASPEED GFX Driver * * This driver is for the ASPEED BMC SoC's 'GFX' display hardware, also called * the 'SOC Display Controller' in the datasheet. This driver runs on the ARM * based BMC systems, unlike the ast driver which runs on a host CPU and is for * a PCIe graphics device. * * The AST2500 supports a total of 3 output paths: * * 1. VGA output, the output target can choose either or both to the DAC * or DVO interface. * * 2. Graphics CRT output, the output target can choose either or both to * the DAC or DVO interface. * * 3. Video input from DVO, the video input can be used for video engine * capture or DAC display output. * * Output options are selected in SCU2C. * * The "VGA mode" device is the PCI attached controller. The "Graphics CRT" * is the ARM's internal display controller. * * The driver only supports a simple configuration consisting of a 40MHz * pixel clock, fixed by hardware limitations, and the VGA output path. * * The driver was written with the 'AST2500 Software Programming Guide' v17, * which is available under NDA from ASPEED. */ static const struct drm_mode_config_funcs aspeed_gfx_mode_config_funcs = { .fb_create = drm_gem_fb_create, .atomic_check = drm_atomic_helper_check, .atomic_commit = drm_atomic_helper_commit, }; static void aspeed_gfx_setup_mode_config(struct drm_device *drm) { drm_mode_config_init(drm); drm->mode_config.min_width = 0; drm->mode_config.min_height = 0; drm->mode_config.max_width = 800; drm->mode_config.max_height = 600; drm->mode_config.funcs = &aspeed_gfx_mode_config_funcs; } static irqreturn_t aspeed_gfx_irq_handler(int irq, void *data) { struct drm_device *drm = data; struct aspeed_gfx *priv = drm->dev_private; u32 reg; reg = readl(priv->base + CRT_CTRL1); if (reg & CRT_CTRL_VERTICAL_INTR_STS) { drm_crtc_handle_vblank(&priv->pipe.crtc); writel(reg, priv->base + CRT_CTRL1); return IRQ_HANDLED; } return IRQ_NONE; } static int aspeed_gfx_load(struct drm_device *drm) { struct platform_device *pdev = to_platform_device(drm->dev); struct aspeed_gfx *priv; struct resource *res; int ret; priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL); if (!priv) return -ENOMEM; drm->dev_private = priv; res = platform_get_resource(pdev, IORESOURCE_MEM, 0); priv->base = devm_ioremap_resource(drm->dev, res); if (IS_ERR(priv->base)) return PTR_ERR(priv->base); priv->scu = syscon_regmap_lookup_by_compatible("aspeed,ast2500-scu"); if (IS_ERR(priv->scu)) { dev_err(&pdev->dev, "failed to find SCU regmap\n"); return PTR_ERR(priv->scu); } ret = of_reserved_mem_device_init(drm->dev); if (ret) { dev_err(&pdev->dev, "failed to initialize reserved mem: %d\n", ret); return ret; } ret = dma_set_mask_and_coherent(drm->dev, DMA_BIT_MASK(32)); if (ret) { dev_err(&pdev->dev, "failed to set DMA mask: %d\n", ret); return ret; } priv->rst = devm_reset_control_get_exclusive(&pdev->dev, NULL); if (IS_ERR(priv->rst)) { dev_err(&pdev->dev, "missing or invalid reset controller device tree entry"); return PTR_ERR(priv->rst); } reset_control_deassert(priv->rst); priv->clk = devm_clk_get(drm->dev, NULL); if (IS_ERR(priv->clk)) { dev_err(&pdev->dev, "missing or invalid clk device tree entry"); return PTR_ERR(priv->clk); } clk_prepare_enable(priv->clk); /* Sanitize control registers */ writel(0, priv->base + CRT_CTRL1); writel(0, priv->base + CRT_CTRL2); aspeed_gfx_setup_mode_config(drm); ret = drm_vblank_init(drm, 1); if (ret < 0) { dev_err(drm->dev, "Failed to initialise vblank\n"); return ret; } ret = aspeed_gfx_create_output(drm); if (ret < 0) { dev_err(drm->dev, "Failed to create outputs\n"); return ret; } ret = aspeed_gfx_create_pipe(drm); if (ret < 0) { dev_err(drm->dev, "Cannot setup simple display pipe\n"); return ret; } ret = devm_request_irq(drm->dev, platform_get_irq(pdev, 0), aspeed_gfx_irq_handler, 0, "aspeed gfx", drm); if (ret < 0) { dev_err(drm->dev, "Failed to install IRQ handler\n"); return ret; } drm_mode_config_reset(drm); drm_fbdev_generic_setup(drm, 32); return 0; } static void aspeed_gfx_unload(struct drm_device *drm) { drm_kms_helper_poll_fini(drm); drm_mode_config_cleanup(drm); drm->dev_private = NULL; } DEFINE_DRM_GEM_CMA_FOPS(fops); static struct drm_driver aspeed_gfx_driver = { .driver_features = DRIVER_GEM | DRIVER_MODESET | DRIVER_ATOMIC, .gem_create_object = drm_cma_gem_create_object_default_funcs, .dumb_create = drm_gem_cma_dumb_create, .prime_handle_to_fd = drm_gem_prime_handle_to_fd, .prime_fd_to_handle = drm_gem_prime_fd_to_handle, .gem_prime_import_sg_table = drm_gem_cma_prime_import_sg_table, .gem_prime_mmap = drm_gem_prime_mmap, .fops = &fops, .name = "aspeed-gfx-drm", .desc = "ASPEED GFX DRM", .date = "20180319", .major = 1, .minor = 0, }; static const struct of_device_id aspeed_gfx_match[] = { { .compatible = "aspeed,ast2500-gfx" }, { } }; static int aspeed_gfx_probe(struct platform_device *pdev) { struct drm_device *drm; int ret; drm = drm_dev_alloc(&aspeed_gfx_driver, &pdev->dev); if (IS_ERR(drm)) return PTR_ERR(drm); ret = aspeed_gfx_load(drm); if (ret) goto err_free; ret = drm_dev_register(drm, 0); if (ret) goto err_unload; return 0; err_unload: aspeed_gfx_unload(drm); err_free: drm_dev_put(drm); return ret; } static int aspeed_gfx_remove(struct platform_device *pdev) { struct drm_device *drm = platform_get_drvdata(pdev); drm_dev_unregister(drm); aspeed_gfx_unload(drm); drm_dev_put(drm); return 0; } static struct platform_driver aspeed_gfx_platform_driver = { .probe = aspeed_gfx_probe, .remove = aspeed_gfx_remove, .driver = { .name = "aspeed_gfx", .of_match_table = aspeed_gfx_match, }, }; module_platform_driver(aspeed_gfx_platform_driver); MODULE_AUTHOR("Joel Stanley <joel@jms.id.au>"); MODULE_DESCRIPTION("ASPEED BMC DRM/KMS driver"); MODULE_LICENSE("GPL"); |